Table of Contents
Advertisement
Maintenance
74
Installation
1 Install the spacer sleeve (stern drive) and the
propeller hub onto the shaft. Fit the propeller to the
spacer sleeve.
2 Drive: Install the nut (5). Place a propeller blade in
the hub and secure it with a wooden wedge
between the propeller blade and hull. Tighten the
nut to 70 Nm.
Reverse gear: Fit the washer (7) and tighten the
nut (6) to 220 Nm. Apply thread locking fluid to the
lock screws (8). Once the lock screws have been
tightened, locking fluid should also be applied to
their heads.
3 Drive: Place the tab washer (3) on the nut. Install
and tighten the lock screw (2) to 20 Nm and bend
one of the tab washer tabs against the bolt head.
The tab washer (3) must be replaced if necessary.
Only Volvo Penta original lock screws (2) or screws
with the same quality may be used.
4 Install one propeller blade to the hub and press in
the cotter pin (1) so that the groove in the pin is
aligned with the lock screw hole (2). Apply thread
locking fluid to the lock screw and tighten it to 10
Nm.
5 Install the blades the same way in consecutive
order. Check that the blades have the same angle
to the propeller shaft and that they move easily.
47711262 01-2019 © AB VOLVO PENTA
Hide quick links:
Advertisement
Table of Contents
