Initial Assembly - Craftsman 119.224000 Owner's Manual

3. INITIAL ASSEMBLY
! llc machine is supplied partly assembled. Prior to use, the following items have to be installed: Open stand, 2-1/2" dust port, Table, Rip
Feilce, 131ade
Tension Knob, Tool holder, and Crank handle.
WAHNING:
To avoid injwy,
do
not attempt to run or use this machine until all parts are assembled and working properly.
a. f\~;sembly the open stand
" Check contents against the parts list.
·· FastHn hnnt panel on io paired legs, using hex carriage bolts, waShers and hex nuts. Do not fully tighten.
- Fasten side panel on to front panel
I
paired legs assemblies using remaining hex carriage bolts, washers and hex nuts.
·· Fa.sten the front and side beams on the paired legs with hex carriage bolts, washers and hex nuts.
- Set stand in an upright position, whilst ensuring
11181
the holes
on
the top
edge
of the panels line up sufficiently to allow hex head
screws to pass through. Tighten fully the hex carrlas:Je bolts and 1ex nuts.
~
Press rubber feet on to the end of stand legs .
. \fVith c1ssistance lift bandsaw and carefully position in place on top of stand.
- Fix in position using hex head screw, through washer, bandsaw base, stand, washer and secure on underside with hex nut. Repeat
procedure for all four corners before tightening fu!ly.
WARNING:
To Avoid back-injury,
gel
help lifling
I
he
bandsaw.
Bend your l<ness,
lift
with your legs, not your back.
ltem No.
1
2
3
4
5
6
I
8
9
10
11
I
12
Front beam
Side beam
Legs
Side panel
r:ront panel
I lex nut
Washer
Hex carriage bolt
Hex
nut
Washer
Hex head screw
Rubber fool
O'!y
2
2
4
2
2
24
24
24
4
8
4
4
Bandsaw open stand
Parts Diagram
~--~~-
··~~~~-~--
I
I
~
- - - - - - - - - - · - - - - - - - - - · - - · - - - - - - ' ' - - - - - - - -
b. Assemble the 2-1/2" dust port to the bandsaw frame with Hex
socket head cap screw and washer. Place the
2-1/2"
dust port on
to tho side of the banclsaw frame.
Locale two Hex. socket head cap screws and two washers from
the bag of loose paris. Mount tile dust port to the bandsaw frame
and instal! a Hex. socket head· cap screw with washer in each
hole, then tighten with M5 Hex "L" wrench. (See FIG.1)
c. Assemble the upper table trunnion to the lower table trunnion
with Carriage Bolt, Glide Piece, Washer and Wing Nut. Place the
table on to the upper table trunnion, taking care when passing tile
saw blade through the slot of the table (See FIG. 2).
Locate four hex bolts and four lock washers from the bag of loose
parts. Mount the table to the upper table trunnion and install a bolt
with washer in each hole, then tighten with adjustable wrench.
5
d. Fasten the guide rail wilh four each wing screw and washer to
the table. Use the hex socket head cap screw, washor and wing
nut for correcting the working tabie flatness. (See FIG. 3)