Summary of Contents for Petsafe YardMax Cordless In-Ground Fence
Page 2
• You may need to trim the hair in the area of the contact points. Never shave your pet’s neck; this may lead to a rash Hereinafter Radio Systems Corporation, Radio Systems PetSafe Europe Ltd., Radio Systems Australia Pty Ltd. and any other affiliate or brand of Radio or infection.
Point • Small Phillips screwdriver • Spade shovel or lawn edger • Circular saw with masonry blade • Staple gun • Wire stripping pliers • Mounting stake For help with setup and training, please visit petsafe.com. +1 (800) 732-2677 petsafe.com...
Underground cables can carry high voltage. Have all underground cables marked before you dig to bury your wire. In most The YardMax Cordless In-Ground Fence system allows you to safely keep your pet within the boundary you set. The PetSafe brand has safely used areas, this is a free service. Avoid these cables when you dig.
(e.g., front yard only). Then the wire makes a U-turn back along the same path and connects back to the fence transmitter. This forms a boundary zone with a double wire (6B). This only works in Traditional mode (B) 5 ft. +1 (800) 732-2677 petsafe.com...
Page 6
(Single Loop) This layout protects off-limits areas like gardens, pools or landscaping by splicing a twisted section from the 5 ft. main boundary wire. This will allow your pet to cross this section without a correction. +1 (800) 732-2677 petsafe.com...
⁄ 1,000 ft. of boundary wire. You may purchase an additional 500 ft. Prepare the Collar spool at the store where you purchased the kit or through the PetSafe ® ⁄ Turn On the Receiver Collar Customer Care Center.
– 14. Once the boundary height setting is established, set the correction level on apply to the (–) wire the receiver collar to level 1 for training. It is now time to bury your boundary wire! +1 (800) 732-2677 petsafe.com...
Bury both boundary wires across the gate opening while keeping them 5 ft. apart. Note: The signal is still active across the gate. Your pet cannot pass through an open gate. Single Loop Pet Area Double Loop +1 (800) 732-2677 petsafe.com...
® neck so that the contact points make contact with your pet’s skin the boundary wire approximately 6 in. inside the pet area (17B). on the underside of his or her neck. Make sure the PetSafe logo is ® 4. If you are in Traditional mode (B) place the boundary flag where right-side up (18A).
Continue watching your pet. If he escapes, remove a leash. the collar and lead him back into the pet area. Start these sessions at • Be sure to place the collar on your dog’s neck with the PetSafe logo ®...
15 seconds. While the receiver collar locks out further static correction, the green light will remain on for 10 seconds. The receiver collar remains locked out until your pet leaves the Pet Area Static Correction static correction zone. Zone +1 (800) 732-2677 petsafe.com...
• Traditional mode (B) only—adjust the boundary width setting to decrease the distance from the boundary wire that the receiver collar activates. Why does the transmitter display a • Your transmitter was built with future updates in mind. Check petsafe.com regularly for announcements regarding Bluetooth technology.
In no event shall Radio Systems Corporation or any of its associated companies be liable for (i) any direct, indirect, punitive, incidental, special or household or municipal waste. For a listing of Customer Care Center telephone numbers in your area, visit our website at www.petsafe.com.
Need help?
Do you have a question about the YardMax Cordless In-Ground Fence and is the answer not in the manual?
Questions and answers