Software Operation; Installing The Sdds Recorder System Software In Your Computer - Sony DFR-E3000 Operation Manual

Sdds recorder system
Hide thumbs Also See for DFR-E3000:
Table of Contents

Advertisement

Available languages

Available languages

Software Operation

Installing the SDDS Recorder System Software in Your Computer

..........................................................................................................................................................................................................
1) MMX Pentium is a trademark of Intel Corporation.
2) Microsoft Windows 95 and Microsoft Windows 98 are trademarks of Microsoft Corporation.
3) AT-GPIB, NI-488.2, and PCMCIA-GPIB are registered trademarks of National Instruments Corporation.
Recommended minimum hardware configuration
The recommended minimum hardware configuration of your IBM PC/AT
or IBM-compatible personal computer is as follows:
CPU:
MMX Pentium
Memory:
64 megabytes or more
Display:
800 600 high color or more
Free space on the hard disk:
10 megabytes or more
CD-ROM drive:
One or more
Floppy disk drive:
At least one drive (2DD/2HD)
RS-232C port (COM port):
D-sub, 9-pin male
LPT port:
D-sub, 25-pin female supporting IEEE-1284 EPP
OS:
Microsoft Windows 95 or Microsoft Windows
98
GP-IB unit and software (for LED optical power adjustment)
GP-IB interface:
AT-GPIB
GP-IB driver:
NI-488.2
Microsoft Windows 98, version 1.50
(These products are manufactured by National Instruments Corporation.)
Before installation
• Check the COM port and LPT port settings.
COM port:
IRQ4, I/O PORT 3F8h, COM1
LPT port:
IRQ7, I/O PORT 378h, EPP mode, LPT1
To use other settings, contact your nearest Sony dealer or service
personnel.
• Make sure the following:
— COM1 and LPT1 ports are set to enable.
— LPT1 is set to EPP.
— The resources of COM1 and LPT1 do not conflict with other devices.
If these conditions are not met, recording error may result.
To check the COM port and LPT port settings
Use BIOS setup. For details, refer to the operating instructions supplied
with your personal computer or contact the manufacturer of the computer.
1)
266 MHz or higher
2)
3)
or PCMCIA-GPIB
3)
software for Microsoft Windows 95 or
3)
15(E)

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dfr-c3000

Table of Contents