Table of Contents
Advertisement
• When the LaneSense system senses the lane has
been approached and is in a lane departure situa-
tion, the left thick lane line flashes yellow (on/off),
the left thin line remains solid yellow and the Lane-
Sense telltale changes from solid white to flashing
yellow.
NOTE:
The LaneSense system operates with the similar
behavior for a right lane departure when only the
right lane marking has been detected.
Left Lane Departure — Both Lanes Detected
• When the LaneSense system is on, the lane lines
turn from gray to white to indicate that both of the
lane markings have been detected. The Lane-
Sense telltale is solid green when both lane mark-
ings have been detected and the system is
"armed" to provide visual warnings in the instru-
ment cluster display and a torque warning in the
steering wheel if an unintentional lane departure
occurs.
• When the LaneSense system senses a lane drift
situation, the left thick lane line and left thin line
turn solid yellow. The LaneSense telltale changes
from solid green to solid yellow. At this time
torque is applied to the steering wheel in the op-
posite direction of the lane boundary.
118
For example, if approaching the left side of the lane
the steering wheel will turn to the right.
• When the LaneSense system senses the lane has
been approached and is in a lane departure situa-
tion, the left thick lane line flashes yellow (on/off)
and the left thin line remains solid yellow. The
LaneSense telltale changes from solid yellow to
flashing yellow. At this time torque is applied to
the steering wheel in the opposite direction of the
lane boundary.
For example, if approaching the left side of the lane
the steering wheel will turn to the right.
NOTE:
The LaneSense system operates with the similar
behavior for a right lane departure.
Changing LaneSense Status
The LaneSense system settings can be configured
through the Uconnect system screen.
Follow these steps to change the LaneSense set-
tings:
1. Press the "Controls" button located on the bot-
tom of the Uconnect touchscreen display.
2. Press the "Settings" button.
3. Press the "Safety & Driving Assistance" button.
When in the Safety & Driving Assistance screen,
you can configure the intensity of the torque warn-
ing and the warning zone sensitivity (early/late)
through the personalization settings.
NOTE:
• When enabled the system operates above 37 mph
(60 km/h) and below 112 mph (180 km/h).
• Use of the turn signal suppresses the warnings.
• The system will not apply torque to the steering
wheel whenever a safety system engages. (anti-
lock brakes, traction control system, electronic sta-
bility control, forward collision warning, etc.)
PARKVIEW REAR BACK
UP CAMERA
Your vehicle is equipped with the ParkView Rear
Back Up Camera that allows you to see an on-
screen image of the rear surroundings of your ve-
hicle whenever the gear selector is put into RE-
VERSE. The ParkView camera is located on the
rear of the vehicle above the rear license plate. The
image will be displayed in the touchscreen display
Advertisement
Table of Contents
