Heat & Glo TRUE-36G-IFT Owner's Manual page 15

To reset the IFT-ECM Control Module:
• Be aware the appliance may be HOT, use
care in accessing the reset switch.
• Turn the appliance off at a wall switch location if so
equipped.
• Wait five minutes to allow possible accummulated gas
to clear.
• Remove decorative front from appliance.
• Locate reset switch inside the appliance. See Figure
3.6. Hold reset switch down for one second and
release. A "beep" will signal module is reset.
Appliances with Wall Switch and Remote
• Turn wall switch back to "ON" position.
main menu on remote control and restart fireplace.
The fireplace will start as it would under normal
circumstances.
Appliances with Wall Switch Only:
• Turn wall switch back to "ON" position. The fireplace
will ignite as it would under normal circumstances.
Appliances with Remote Only:
• Turn fireplace back on using the main menu on the
remote control. The fireplace will ignite as it would
under normal circumstances.
• Reinstall decorative front on appliance.
• If the IFT-ECM re-enters the LOCK-OUT condition
after this procedure, contact your dealer for service.
Heat & Glo • TRUE-36-IFT, TRUE-42-IFT, TRUE-50-IFT Owner's Manual • 2461-981 Rev. N • 6/19
Appliance ON/OFF:
Your TRUE fireplace is supplied with a fully functional
remote control. This remote controls:
• ON/OFF Functions
• Flame height adjustments
• Thermostat
• Electric Ember Bed
• Cold Climate Feature
• Optional Heat-Zone
Please refer to the instructions included with the remote
control for more detailed operating instructions.
Go to
Electric Embers
• Electric Embers are a standard feature on all TRUE
fireplaces.
• The intensity of the these lights may be controlled
through the remote control included with your fire-
place.
Optional Heat-Zone
Once the optional Heat-Zone
fied service technician during the appliance installation
process, follow the instruction supplied with the kit for op-
eration.
• Use the RC400 remote to set the Heat-Zone
MED, LO or OFF. The Fan Speed dynamic icon is
used to change the setting. Refer to the RC400 Quick
Reference Guide in the appliance manual bag.
Kit
®
Gas Kit
®
Kit is installed by a quali-
®
to HI,
®
15