Table of Contents
Advertisement
4.3.2
Keyboard Control Panel
1. Remove the rear cover, as described earlier.
2. Refer to fig. "Keyboard control panel" below.
3. Remove the T10 parker screws [1].
4. Unplug connector [2].
5. Remove the unit.
6. Release clips [3] and remove the board.
When defective, replace the whole unit.
3
2
Figure 4-7 Keyboard control panel
4.3.3
Side I/O Panel
1. Remove the rear cover, as described earlier.
2. Unplug connector [a].
3. Remove screws [b] and remove the complete module. One
of the screws is T10 tapping, the other one is T10 parker.
See fig. "Side I/O module".
4. Remove T10 parker screw [c]. See fig. "Side I/O panel 1".
5. Push catch [d] (located at the underside of the bracket) and
slide the unit to the right from its bracket [e]. See fig. "Side
I/O panel 2".
6. To remove the PWB from its bracket, you have to lift the
catch [f] located on top of the headphone connector. At the
same time, slide the PWB out of its bracket [g]. See fig.
"Side I/O panel 3".
When defective, replace the whole unit.
b (1x)
Figure 4-8 Side I/O module
1
1
G_16850_007.eps
090207
a
b (1x)
G_16860_066.eps
Mechanical Instructions
Figure 4-9 Side I/O panel [1/3] top side
2 e
Figure 4-10 Side I/O panel [2/3] bottom side
010207
LC7.1A LA
4.
c
2 d
G_16860_076.eps
EN 13
G_16860_075.eps
010207
010207
Advertisement
Table of Contents
