Table of Contents
Advertisement
EN 12
4.
LC7.1A LA
4.2
Service Positions
For easy servicing of this set, there are a few possibilities
created:
•
The buffers from the packaging.
•
Foam bars (created for Service).
•
Aluminium service stands (created for Service).
Note: the aluminium service stands can only be used when the
set is equipped with so-called "mushrooms". Otherwise use the
original stand that comes with the set.
4.2.1
Foam Bars
Required for sets
1
42"
Figure 4-4 Foam bars
The foam bars (order code 3122 785 90580 for two pieces) can
be used for all types and sizes of Flat TVs. See figure "Foam
bars" for details. Sets with a display of 42" and larger, require
four foam bars [1]. Ensure that the foam bars are always
supporting the cabinet and never only the display. Caution:
Failure to follow these guidelines can seriously damage the
display!
By laying the TV face down on the (ESD protective) foam bars,
a stable situation is created to perform measurements and
alignments. By placing a mirror under the TV, you can monitor
the screen.
Mechanical Instructions
4.2.2
1
4.3
4.3.1
E_06532_018.eps
171106
Aluminium Stands
Figure 4-5 Aluminium stands
The MkII aluminium stands with order code 3122 785 90690,
can also be used to do measurements, alignments, and
duration tests. The stands can be (dis)mounted quick and easy
by means of sliding them in/out the "mushrooms". The stands
are backwards compatible with the earlier models.
Important: For (older) FTV sets without these "mushrooms", it
is obligatory to use the provided screws, otherwise it is possible
to damage the monitor inside!
Assy/Panel Removal
Rear Cover
Warning: Disconnect the mains power cord before you remove
the rear cover.
Caution: For AmbiLight sets, it is compulsory to open the
additional cover first, and unplug the connectors [1] as
indicated in figure "Cover AmbiLight Interface".
1
Figure 4-6 Cover AmbiLight Interface
1. Place the TV set upside down on a table top, using the
foam bars (see part "Service Position").
2. Remove rear cover screws and the stand (if mounted).
3. Remove rear cover.
E_06532_039.eps
290507
H_17270_010.eps
060707
Advertisement
Table of Contents
