Advertisement
Slide 107
Press and hold for 3 Sec.
LED/Switch Check
While in Service Mode, pressing the Chime and Wrinkle Prevent keys for 3
seconds, will start a LED/Switch Test. To exit the test at any point, press the same
keys again for 3 seconds or press the OFF key to exit Service Mode. Perform the
check by pressing the keys which toggle the LED's on and off.
All switch pads must be pressed within 5 minutes for this test to pass. PA will be
displayed for five (5) seconds once all switch pads have been pressed and this test
is completed. Following 10 seconds of inactivity at any point, the test will exit
without any display. The Power Off switch pad must be pressed twice within thirty
(30) seconds to cancel this test
Refer to Technical Data Sheet for Detailed Instructions
Slide 108
Diagnostic Codes
Access Diagnostic Codes by entering the Service Mode and pressing Wrinkle
Prevent. A d will be displayed.
Rotate the Cycle Selector Knob in either direction to step through the list of
codes one code at a time.
Refer to Technical Data Sheet for Detailed Instructions
LED/ Switch Check
Press
Diagnostic Codes
42
Advertisement
