Lubrication Table - International Harvester Company Cub Cadet 682 Operator's Manual

1 - Engine oil level 1 - Engine oil level gauge.
gauge.
before each before each
(check (check
2 - knuckles knuckles (2).
2 - Steering Steering
. . . .
3 ' Transmiss'Q" °"
3 ' Transm'ss'q" °" ""3"-
Front Front
4 - 4 - Axle pivot pin. Axle pivot pin.
5 -Engine
oil drain oil drain
5 - Engine
6 - Transmission oil level
6 - Transmission oil level
and filler plug. and filler plug.
NOTE: When the r e d hand of t h e hour meter is in the red NOTE: When the red hand of t h e hour meter is in the red
lllllllflATlllll
llIIIIIGATIIIII GIIIIIE
After Every After Every 10 Hours of Operation
‐ ‐
sufficient new oil to
the level gauge. Do not overfiil. Do not operate the the level gauge. Do not overfill. Do
use) use) engine if
the gauge. the gauge.
{Use
(2). {
to flush out
to flush
" " 9 "
‐ After Every 30 Hours of Operation ‐ After Every 30 Hours of Operation
plug. plug.
GIIIIIE
10 Hours of Operation
Check the oil
Check the oil
(with (with
sufficient new oil to
bring bring
the oil level the oil level
engine if
Use IH 251H EP grease or equivalent No. 2 multi‑ 251H EP grease or equivalent No. 2
IH
purpose lithium grease and apply lithium
purpose grease
out old
old grease grease and dirt.
NOTE: After the first 10 hours NOTE: After the first 10 hours
filter and with
replace
filter and with
replace
AND FUEL SYSTEM". s v s r a r " .
AND FUEL
hours and every 100 hours of hours and every 100 hours of
Use Use IH 251H EP grease or equivalent No. 2 multi‑ 251H
lH EP grease or equivalent
purpose lithium grease and apply
purpose lithium grease and apply sufficient grease
to flush to flush out out old old grease and grease and dirt.
rotate rotate
necessary to necessary to
grease fitting. grease fitting.
While the oil is warm, remove the drain While the oil is warm, remove the drain
drain all of the oil from the crankcase. Replace the drain all of the oil from the crankcase. Replace the
drain drain Refill the crankcase with new oil up to the Refill the crankcase with new oil up to the
plug. plug.
"FULL" mark on the oil level "FULL" mark on the oil level

"LUBRICATION TABLE"

"LUBRICATION TABLE" for
use.
use.
viscosity to viscosity to
Check the oil with the Check oil with the engine stopped. Keep the
the
lubricant up to level lubricant up to level
transmission case. transmission case.
areas maintenance is areas maintenance is
36 36
stopped) and add stopped) and add
the the engine engine
it to the "FULL" mark on it to the "FULL" mark on
not
operate the
below the "LOW" mark below the "LOW" mark
is is
and sufficient grease sufficient
apply
and dirt.
only, remove the remove the oil
only,
new filter. Refer
a new filter. Refer to
a to
the oil filter after oil filter after 50
Change the Change
thereafter. thereafter.
operation operation
No.
sufficient grease
dirt. NOTE: NOTE:
the front axle to reach the front axle to reach the
the
plug (5) plug (5)
gauge. Refer gauge. Refer
for the proper the proper quantity and
quantity
engine stopped. Keep the
6 on the rear of the 6 on the rear of the
plug plug
required. required.
on on
multi‑
grease
oil
"ENGINE
"ENGINE
50
multi‑
2
It may be It may be
and and
the the
to to
and