Speed Control Lever Stop - International Harvester Company Cub Cadet 682 Operator's Manual

BREAK-IN PROCEDURE
TRACTOR
Never operate a new
under full load. Break it in carefully as shown
‐‑
in the table below.
Engine Thottle
Control Lever
Period Position
3/4
3rd through _ _ _ _
13th hour

SPEED CONTROL LEVER STOP

An adjustable speed control lever stop is
vided
to allow the operator to
determined
speed.
not
Do bypass the speed control
obtain a tractor
higher
speed is desired, reset the stop. Refer to
"Instrument and Controls".
STARTING THE ENGINE
sure there
1. Be is an adequate supply of
gasoline in the fuel tank.
CAUTION! To avoid fire or
tighten fuel c a p securely.
remove
the fuel tank c a p
fuel tank when the engine is running, or hot,
or indoors. Also, do not smoke when work‑
around flammable fuel.
i n g
2. Be sure the fuel shut-off valve is open.
OPERATING
engine immediately
F - u l l n _
X Normal
mowing
pro‑
return
to a pre‑
lever stop to
If a
speed. higher
injury,
Never
or fill
t h e
TIIE
TRACTOR
3. Pull choke control button to full choke
tion. Less choking may be necessary due to
variations in temperature, grade of fuel,
Little or no choking will be
warm.
engine is
Place the throttle
4.
start
5. To the
switches must be activated by
brake all
pedal the way
take-off clutch switch to the dis‑
power
engaged position.
NOTE: The
s p e e d
neutral when the brake pedal is
down.
the
way
6. Turn the
ignition key
"START"
position
starts; however do not operate the
the engine
starter for more than 30 seconds at
time. If the engine does not
turn the
time, key "OFF"
minutes, then try again.
7. After the
engine
brake pedal and gradually push the choke
control button all the
choke to enrich the fuel mixture, except as
start
necessary to
STOPPING
THE ENGINE
Move the throttle lever to
and allow the engine to idle for a short
tion
before
time stopping. Then
"OFF" position.
COLD WEATHER
Engine starting is possible in cold weather
correct
providing the
used, the battery is
proper starting procedure is
best procedure for
near
or below freezing is as follows:
needed when the
off "SLOW"
just position.
engine, safety starting
pressing the
down and
moving
control lever will return to
pressed
clockwise to the
and release soon
it as
any
start
within this
and wait
a few
starts, slowly release the
in. Do not use the
way
the
engine.
the
"SLOW"
turn the
k e y to the
STARTING
weight of engine oil is
fully charged, and
followed. The
starting at temperatures
posi‑
etc.
the
all
as
one
posi‑
the