Cobalt Digital Inc Cobalt Qube 2 User Manual page 116

Chapter 4
To assign dynamic or static network information to the DHCP clients:
1. On the Administrator Site screen, click Control Panel on the left.
The Service Settings table appears.
2. Click Parameters next to the DHCP Server option. The DHCP
Parameters page appears with three options.
3. Click Settings for DHCP Clients. The Settings for DHCP Clients
table appears.
•
•
4. Click Add Dynamic Address Assignment. The Add New Dynamic
Address Assignment table appears.
Enter the lower end and upper end of a range of IP addresses for the
DHCP server to assign dynamically. For example, if you enter
205.3.4.1 – 205.3.4.3, the DHCP server assigns 205.3.4.1, 205.3.4.2
and 205.3.4.3 to the DHCP clients.
Click Confirm Address Assignment. The UI returns to the DHCP
Parameters page.
5. Click Add Static Address Assignment. The Add New Static
Address Assignment table appears.
IP Address In this field, enter the IP address that the DHCP server
will consistently assign to the network device with the specific
hardware ethernet (MAC) address.
MAC address In this field, enter the hardware ethernet (MAC)
address of the network device to which the DHCP server will
consistently assign the IP address.
Click Confirm Address Assignment. The UI returns to the DHCP
Parameters page.
6. Click Back in the DHCP Parameters page.
7. If DHCP has not been enabled, click the check box next to
Dynamic Host Configuration Protocol (DHCP) Server to enable
this option.
8. Click Save Changes in the Service Settings table. The UI screen
refreshes.
102
to assign dynamic network information, go to Step 4.
to assign static network information, go to Step 5.
Note: You must save the changes in the Service Settings table
for the DCHP information to take effect.