Perkins 1000 Series Workshop Manual page 326

Bendix Compressors
To remove and to fit
To remove
1 Drain the engine cooling system.
2 Release the air pressure in the air system.
Disconnect the air pipes and the coolant pipes (A1)
to and from the cylinder head of the compressor.
3 Remove the lubricating oil pipe (A6) which is
fitted between the compressor and the engine
cylinder block.
4 If necessary, remove the steering pump from the
rear of the compressor.
5 Loosen the two setscrews (A3) of the support
bracket (A4) at the rear end of the compressor.
Remove the two fasteners (A5) which fasten the
support bracket to the cylinder block or filter head
and remove the bracket.
Note: Spacers (A2) are used between the bracket
of the 1W150R compressor and the compressor
body.
Remove the nut from the stud at the bottom of the
compressor flange. Remove the nut (A7) from the
stud at the front of the timing case and remove the
compressor from the engine.
If it is necessary to remove the idler gear of the
compressor, see to operation
Perkins Phaser/1000 Series, April 1995
24A-04
15A-03B.
AUXILIARY EQUIPMENT
1
7
6
24A
2 3
5 4
PA294
24A.11