Bearing Retainer - Makita BHR240 Technical Information

R
epair
[3] DISASSEMBLY/ASSEMBLY
[3] -6. Swash Bearing Section (cont.)
DISASSEMBLING
4) Move Piston cylinder to the rear dead center position (Fig. 26).
5) Remove Swash bearing section from Inner housing by pulling in the direction of the arrow (Fig. 27).
Fig. 26
Piston cylinder
Swash bearing section
6) Remove Ball bearing 606ZZ from Gear housing complete using the removed Swash bearing section as a jig as follows;
Insert Cam shaft of Swash bearing section into the Ball bearing again. Tilt the Ball bearing a little bit by moving swash
bearing section as illustrated to left in Fig. 28. Ball bearing 606ZZ can now be removed by lightly tapping the edge of
Gear housing complete with plastic hammer as illustrated to right in Fig. 28.
Fig. 28
7) Remove Ring 8 using 1R022, 1R023 and 1R281 as illustrated in Fig. 29.
8) Remove Ball bearing 608ZZ using 1R269. Flat washer 8 and Bearing retainer can now be removed by hand (Fig. 30).
Fig. 29
1R022
Ring 8
Ball bearing
608ZZ
Piston cylinder
in the rear dead center position
Gear housing
complete
Swash bearing section
used as a jig
Fig. 27
Swash bearing section
Ball bearing 606ZZ
Fig. 30
1R269
1R281
Ball bearing
1R023
608ZZ
P 9/14
Inner housing
Flat washer 8
Bearing
retainer