Table of Contents
Advertisement
R
epair
6. Reassemble swash bearing section temporarily to gear housing, and hold gear housing as illustrated in Fig. 8H.
So, swash bearing section tilts in the direction of arrow.
Keeping the illustrated position, disassemble swash bearing section by striking the edge of gear housing
with plastic hammer. So, ball bearing 606ZZ can be removed together with swash bearing section.
7. Swash bearing section can not be disassembled in one action by pressing cam shaft with arbor press, because
retaining ring S-7 is assembled between ball bearing 608ZZ and compression spring 7.
Take the following steps for disassembling them.
1. Disassemble ring 8 by pressing with arbor press as illustrated in Fig. 9.
2. Disassemble ball bearing 608ZZ with bearing extractor as illustrated in Fig. 9A.
3. Disassemble flat washer 8 and bearing retainer as illustrated in Fig. 9B.
4. Disassemble helical gear 26 by pressing with arbor press as illustrated in Fig. 9C.
1R236 Round bar
for arbor
1R022 Bearing
Ring 8
1R023 Bearing
5. Disassemble swash bearing 10 and clutch cam as illustrated in Fig. 9D. And disassemble ball bearing 606ZZ
with bearing extractor as illustrated in Fig. 9D.
6. Disassemble retaining ring S-7 with retaining ring plier as illustrated in Fig. 9E.
7. Separated compression spring 7 and spur gear 10 from cam shaft as illustrated in Fig. 9F.
Swash
bearing 10
Clutch cam
Fig. 9D
Fig. 8H
Ring 8
extractor plate
extractor ring
Fig. 9
Retaining ring S-7
Ball bearing
606ZZ
Fig. 9E
Bearing retainer
Ball bearing
608ZZ
Fig. 9A
Fig. 9B
Cam shaft
P 13 / 19
1R236 Round bar
Flat washer 8
Helical
gear 26
Fig. 9C
Spur gear 10
Compression
spring 7
Fig. 9F
for arbor
Advertisement
Table of Contents
