Miele KFN 37232 iD Operating And Installation Instructions page 73

For additional stability of the appli-
ance in the unit, push the rods sup-
plied in underneath the appliance
between it and the floor of the housing
unit:
 Then secure handle  to one of the
rods .
 Use the handle to push the rod into
the guide as far as it will go. Remove
the handle and fit it to the other rod
and push this into its guide as far as it
will go. Important! Keep the handle
somewhere safe in case you ever
need to fit the appliance into a new
housing unit
 Close the appliance doors.
Installing the appliance
Fitting the furniture doors
The upper edge of the appliance fur-
niture doors should be aligned with
the height of the furniture doors of the
adjacent kitchen units.
The furniture doors must be mounted
free of tension.
The following chapter describes the
installation of furniture doors with a
furniture front of at least 16-19 mm
thickness.
Carry out the following steps on both
doors.
 A gap of 8 mm is set ex-works
between the appliance door and the
fixing bracket. Double check this gap
and reset it if necessary.
 Push fitting aids  up to the height of
the furniture door: the lower edge X
of the fitting aids must be at the same
height as the upper edge of the fur-
niture door being fitted (see  on the
diagram).
73