On furniture with door fittings (e.g.
stubs, seals etc.):
the dimension of these must be taken
into account when making sure there
is a gap all round of 42 mm.
Pull the appliance forwards by the
appropriate dimension.
Check again, to make sure there is a
gap of 42 mm to the front edges of
the door fittings.
Tip: If possible, remove door fittings
and push the appliance into the niche
until all fixing brackets at the top and
bottom are in line with the front edge of
the housing unit side wall.
Align the appliance on both sides by
altering the adjustable feet using the
spanner supplied.
Installing the appliance
Securing the appliance in the
niche
Press the appliance against the side
of the housing unit on the hinge side.
Screw chipboard screws through
the hinge plates at the top, bottom
and then the middle to secure the ap-
pliance to the housing unit.
71