Table of Contents
Advertisement
The dehumidifying process takes a maximum of 20 minutes. If the
mains illuminated, the process must be repeated.
It is necessary to wait for one hour between dehumidifying processes as the oil in
the vacuum pump gets hot. During this time, the
but they cannot be operated.
9
Trouble-shooting
9.1
What to do if ...
This section lists faults that can be solved simply by following the instructions given. If
another fault is displayed or the fault cannot be remedied, please call Customer Ser-
vices.
... the appliance is not working
Possible cause
▪ A household fuse or circuit
breaker has tripped due to
an overload.
▪ The fuse or circuit breaker
keeps blowing.
▪ An interruption in the power
supply.
▪ The appliance is faulty.
▪ Repeated vacuuming has
caused the appliance to
overheat.
▪ The appliance is in a cool-
ing phase between two de-
humidifying processes. Dur-
ing this time, the
buttons are illuminated, but
they cannot be operated.
... insufficient vacuum in the bag
Possible cause
▪ The vacuuming level selec-
ted was too low for the par-
ticular foodstuff used.
▪ The suction inlet of the va-
cuum pump is obstructed.
▪ The bag is not airtight.
Solution
▸ Replace or switch the fuse back on.
▸ Call Customer Services.
▸ Check the power supply.
▸ Call Customer Services.
▸ Allow the appliance to cool down before using again.
▸ Wait one hour before repeating the dehumidifying
process.
and
Solution
▸ Select the next highest level.
▸ Ensure the bag is not obstructing the suction inlet of
the vacuum pump.
▸ Vacuum seal the food in a new bag, selecting a
higher level for the sealing time if necessary.
9 Trouble-shooting
button re-
and
buttons are illuminated,
19
Advertisement
Table of Contents
