Richmond GTR120 Programming And Operating Instruction Manual

Richmond GTR120 Programming And Operating Instruction Manual

Wireless

Advertisement

Quick Links

Wireless Keypad
Model: GTR120
Programming and Operating Instruction Manual
NOTE: Please read this manual carefully before install and use.
1300 474 246
sales@richmondau.com www.richmondau.com

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the GTR120 and is the answer not in the manual?

Questions and answers

Summary of Contents for Richmond GTR120

  • Page 1 Wireless Keypad Model: GTR120 Programming and Operating Instruction Manual NOTE: Please read this manual carefully before install and use. 1300 474 246 sales@richmondau.com www.richmondau.com...
  • Page 2: Keypad Description

    Introduction Thank you for purchasing the Wireless Keypad GTR120. This wireless keypad will help you provide easy and secure access to any persons you trust, without having to program a lot of remotes. Be sure to read the manual carefully and completely before permanently mounting the keypad, please program the keypad and test its range before finalising installation.
  • Page 3 2 seconds before returning to normal operation. Please try again. NO TE: If the Keypad GTR120 is installed outside of the gate to open the gate, and no Keypad is installed inside of the gate, we strongly recommend you set the auto-close function on the circuit board in the control box.
  • Page 4 1 second. If an error has occurred, the beep will sound for 2 seconds before returning to normal operation. Please try again. If the Keypad GTR120 is installed outside of the gate to open the gate, and no Keypad is installed NOTE: inside of the gate, we strongly recommend you set the auto-close function in circuit board in control box.
  • Page 5 Fig.6 suggested mounting position The wireless keypad GTR120 should be installed outside of the property (Pull to Open) and on the same side of the driveway where the control box is installed. The distance between the keypad and control box should not exceed 5 meters.
  • Page 6 Installation of the kevoad Note: The mounting holes of the keypad have not been poked through you should use a tool with sharp head to punch/poke them. Mount the keypad by following the below figure. punch/drill/poke through the mounting holes before you install the keypad How to increase the control distance ol kewad The standard range of the Keypad is 5~1 O meters.

Table of Contents