Related Manuals for Rain-Flo Irrigation 2 Series 2600 2015
Summary of Contents for Rain-Flo Irrigation 2 Series 2600 2015
- Page 1 MODEL 2600 SERIES II RAISED BED PLASTIC MULCH LAYER ASSEMBLY INSTRUCTIONS Rain-Flo Irrigation 929 Reading Road East Earl, Pa 17519 717-445-3000...
- Page 2 STEP 1 Standard parts shipped with equipment: Yellow Arm Set Cover Disk Set Dirt Shield Set Press Wheel Set...
- Page 3 STEP 2 & P ellow ress heels See Operating Manuel for adjustments. Rain-Flo Irrigation ynch Remove lynch pin from hole on yel- Yellow Arm low arm and slide yellow arm through press wheel and into hinge. Fasten Rain-Flo Irrigation in place with lynch pin.
- Page 4 STEP 3 isks AnD hielDs See Operating Manuel for adjustments. Rain-Flo Irrigation Dirt Shield Cover Disk Rain-Flo Irrigation Slide disk bracket over end of yellow bar and tighten in place with yellow lock handle. Install dirt shield as shown, by slid- ing end through hole and fastening with tee lock handle.
- Page 5 STEP 4 hisel eeth See Operating Manuel for adjustments. Chisel teeth are upside down for shipping. Rotate chisel tooth till tip is on bottom.
- Page 6 STEP 5 nstAlling APe AnD lAstiC See Operating Manuel for adjustments. Drip Tape: Remove plate with locking clamp(A). Slide drip roll onto rod, press plate(A) tight against roll and tighten tee-handle on clamp. Feed drip tape through swing arm guide and stationary guide (B) then into down pipe(C).
- Page 7 STEP 6 rACtor Connect to 12V battery. Hook up to tractor pto. Note: Small 12V battery mounted on machine will also work. Bolt sensor square with machine.
- Page 8 ~2015 Edition~ Rain-Flo Irrigation (717) 445-3000...