Epson EMP-822 Service Manual page 97

When installing the PS Ballast Assy., check the following.
• The
• The AC Inlet is set so that the AC Cable come to the top.
• The tube part of the AC Inlet is not crossing over the Lamp Duct. (To prevent the
AC Cable from being caught between the IF Board Assy. and the Lamp Duct,
when the MA Board Assy. is installed.)(EMP-822/83 only)
SEIKO EPSON
EMP-822/EMP-83/EMP-X5/EMP-S5
AC Cable is secured to the ditch of the Lower Case.
Lower Case
Lamp Duct
Figure 4-47.
AC Inlet
Figure 4-48.
4-48
AC Cable
AC Cable
Revision:A