Epson EMP-822 Service Manual page 80

• (1)'s Routing
1).Route the cable of the Lamp Lid Detection Switch under the MA Plate, and
through the slit shown in the figure below in the direction of the arrow.
2).Connect to CN700 on the MA Board Assy.
• (2), (4)'s Routing
1). Route the Lamp Fan Cable twice around the Speaker Cable, then connect
the connector.
2). Route the Intake Fan1 Cable twice around the Intake Duct, then connect
the connector.
SEIKO EPSON
EMP-822/EMP-83/EMP-X5/EMP-S5
Intake Duct
Intake Fan1 Cable
Connector (CN700)
MA Plate
Lamp Lid Detection Switch
Figure 4-25.
Lamp Fan Cable
Figure 4-26.
4-31
Speaker Cable
Revision:A