Epson EMP-822 Service Manual page 31

Lamp or Temp indicator flashes orange: Warning
Indicator Status
High Temp Warning
Replace Lamp
SEIKO EPSON
EMP-822/EMP-83/EMP-X5/EMP-S5
ON Blink
Table 3-3. LED Indicator Status (Warning)
Projector
Status
(This is not an abnormality. However, if the temperature rises too high
again, projection stops automatically.)
• Check that the air filter and air exhaust vent are clear, and
that the projector is not positioned against a wall.
• If the air filter is clogged, clean or replace it.
(refer to
Filter Assy." (p.
Replace it with a new lamp.
If you continue to use the lamp after the replacement period has passed,
the possibility that the lamp may explode increases. Replace it with a
new lamp as soon as possible. (refer to
Unit" (p.
OFF Varies according to the projector status
Problem and Remedy
3.3.2 "Abnormality Check" (p. 12) /4.3.2 "Removing the Air
13))
12))
3-5
4.3.1 "Removing the AS Lamp
Revision:A