Download Print this page

Operational Principles; Electrical Safety; Operational Safety - LYSON MINIMA Series Manual

Honey extractors with manual or electric drive
Hide thumbs Also See for MINIMA Series:

Advertisement

GENERAL SAFETY
1.

OPERATIONAL PRINCIPLES

Prior to device usage initiation, refer to the
following manual and act according the
guidelines contained therein. The manufacturer
shall not be held accountable for any damages
caused by improper usage of the device or its
improper handling
.
1.1. Operational principles
1. The honey extractor is intended to centrifuge
the honey from the frames.
2. The honey extractor must be washed
thoroughly prior to usage with water containing
slight amount of agents admissible to be used in
cleaning the devices coming into contact with food
or by means of a pressure washer.

1.2. Electrical safety

1. Power supply electric installation must be
equipped with RCD with nominal tripping
current In below 30 mA. Functioning of
overcurrent circuit breaker must be checked
periodically .
2. If non-detachable power supply cable gets
damaged and must be replaced, it must be
performed at a guarantor's or by a
specialised repair centre or by a qualified
person in order to avoid any threat. Do not
operate the honey extractor when the power
supply cable is damaged.
3. Prior to plugging in the device to the mains,
check whether controller is switched off. 0/1
switch on the controlling panel should be in
"0" position.
4. Check the honey extractor and the power
source for nominal voltage compliance.
5. Be careful while connecting the device to the
mains.
Hands must be dry!
The floor on which the extractor has been
placed must be dry!
6. The honey extractor lid must be closed during
spinning!. It is forbidden to open the lid during
spinning.
7. While spinning, the honey extractor must not be
displaced.
8. In case of the honey extractor with electric
controlling, the engine and the controller must be
protected against damping; ( also during the
storage).
9. It is forbidden to pull the supply cable. The
supply cable must be kept away from heat
sources, sharp edges and its good technical state
must be taken care of.

1.3. Operational safety

1. The following equipment is not intended to be
used by persons with limited physical, sensory or
mental capabilities (including children) or persons
inexperienced or unfamiliar with that type of
equipment unless the usage occurs under
supervision or in line with the equipment operating
manual provided by safety supervising persons.
One must make sure that children do not play with
the honey extractor.
2.
In case of any damage to the honey
extractor, in order to avoid the danger, the repairs
may be performed solely by a specialist servicing
centre or a qualified person.
3.
It is forbidden to perform any
maintenance works or repairs when the device is
in operation.
4. All shields must be permanently attached to
the honey extractor while operating it.
5. The device cannot be activated and stored
with the ambient temperature below 0º C.
Honey extractor cannot be activated when the
ambient temperature drops below 5º C. When the
honey extractor has been moved from a room with
a lower temperature to a room with a higher
temperature, prior to its activation one must wait
until the device has achieved the ambient
temperature.
It is forbidden to make any repairs while the
device is under operation
It is forbidden to remove any shields while the
device is under operation

Advertisement

loading