Calibration 1 And 2 (Screens 22 And 23); Troubleshooting (Screens 35-37) - Graco ProMix 2KE Operation

Setup Mode Details
Calibration 1 and 2 (Screens 22
and 23)
NOTE: See Pump Calibration, page 33, for detailed
instructions.
Calibration 1 (Screen 22) displays if
Setup Home (Screen 17). This screen displays the
pump factor for Pump A and Pump B. The factor is the
pump displacement per inch. The system starts at the
default factor for the pump size chosen on Configure 1
(Screen 18, page 45). Factor values update automati-
cally as needed based on calibration results from Cali-
bration 2 (Screen 23). Factor values also can be set on
this screen, from 5 to 50 cc/in.
Pump B
Factor
Pump A
Factor
F . 43. Calibration 1 (Screen 22)
IG
Press to display Calibration 2 (Screen 23). This
screen allows the user to perform a calibration. It dis-
plays Pump A and Pump B factors, the target dispense
volume, the actual dispense volume (0 to 9999 cc), and
the material to dispense.
Pump B
Factor
Pump A
Factor
Start Pump
Cancel Pump
Calibration
Calibration
F . 44. Calibration 2 (Screen 23)
IG
48
is selected on
Material to
dispense
Target
dispense
volume
Actual
dispense
volume
Home
• Press
brate. Press
• Press
pump (A or B). Press
NOTE: If you press
check to be sure that you have selected Pump A or
Pump B.
• Press
ume field. Press
9999 cc). Press
Press
field is correct.
• Use
(Screen 22) and Calibration 2 (Screen 23).
Troubleshooting (Screens
Home
35-37)
Screens for testing system controls can be accessed by
setting the password to 9909. See Configure 3 (Screen
20), page 46, to set or change the password.
After setting the password to 9909, press
Setup. Press
(Screen 17) displays, with troubleshooting screen
options.
Troubleshooting
screen options
appear here.
F . 45. Setup Home with Troubleshooting
IG
to highlight the pump you wish to cali-
. An X displays in the box.
to start the calibration on the highlighted
to cancel the calibration.
but calibration does not begin,
to highlight the actual dispense vol-
to set the volume (from 0 to
to move between digits.
to change a digit. Press
to toggle between Calibration 1
to reenter Setup. Setup Home
when
to exit
3A0868L