Steps
1
Using the alignment posts, adhere the keyboard-controller board into place on the palm-rest assembly.
2
Connect the keyboard-controller board-cable to the keyboard-controller board and close the connector latch.
3
Connect the keyboard cable to the keyboard-controller board and close the connector latch.
4
Connect the keyboard-backlight cable to the keyboard-controller board .
5
Replace the two screws (M2x1.9) that secure the keyboard-backlight cable to the keyboard-controller board.
Next steps
1
Install the battery.
2
Install the
2230 solid-state
3
Install the
2280 solid-state
4
Install the
base
cover.
5
Follow the procedure in
Left I/O-board
Removing the left I/O-board
Prerequisite
1
Follow the procedure in
2
Remove the
base
cover.
3
Remove the
2230 solid-state
4
Remove the
2280 solid-state
5
Remove the battery.
About this task
The following image indicates the location of the left I/O-board and provides a visual representation of the removal procedure.
drive. (if applicable)
drive. (if applicable)
After working inside your
Before working inside your
drive. (if applicable)
drive. (if applicable)
computer.
computer.
31