Adjusting The Tilt; Selecting The Input Signal (Input Button) - Sony SDM-G206W Operating Instructions Manual

No need for specific drivers
The monitor complies with the "DDC" Plug & Play standard and
automatically detects all the monitor's information. No specific driver
needs to be installed to the computer.
The first time you turn on your computer after connecting the monitor, the
setup Wizard may appear on the screen. In this case, follow the on-screen
instructions. The Plug & Play monitor is automatically selected so that
you can use this monitor.
The vertical frequency turns to 60 Hz.
Since flickers are unobtrusive on the monitor, you can use it as it is. You
do not need to set the vertical frequency to any particular high value.

Adjusting the tilt

This display can be adjusted within the angles shown below.
Grasp the lower sides of the LCD panel, then adjust screen tilt.
To use the display comfortably
This display is designed so that you can set it up at a comfortable
viewing angle. Adjust the viewing angle of your display
according to the height of the desk and chair, and so that light is
not reflected from the screen to your eyes.
Note
When adjusting the screen tilt, make sure not to knock or drop the display
off the desk.
Approx. 20°
Selecting the input signal
(INPUT button)
Press the INPUT button.
The input signal changes each time you press this button.
On-screen message
(Appears about 5 seconds on
the upper left corner.)
INPUT1 : DVI-D
INPUT2 : HD15
9
(GB)
Input signal configuration
DVI-D input connector
(digital RGB) for INPUT1
HD15 input connector
(analog RGB) for INPUT2