Setup 5: Adjusting The Tilt; Selecting The Input Signal (Input Button) - Sony SDM-S74 Operating Instructions (primary manual) Operating Instructions Manual

Setup 5: Adjusting the tilt

This display can be adjusted within the angles shown below.
Hold both sides of the LCD panel, then adjust screen
angles.
SDM-S94 only
approx.
175°
approx. 175°
To use the monitor comfortably
Adjust the viewing angle of your monitor according to the height
of your desk and chair, so that light is not reflected from the screen
to your eyes.
Note
When adjusting the screen tilt and height, proceed slowly and carefully,
making sure not to hit the monitor against the desk.
10
approx. approx.
5° 30°
Selecting the input signal
(INPUT button)
Press the m/M buttons.
The input signal change each time you press these buttons.
INPUT
On-screen message
(Appears about 5 seconds on
the upper left corner.)
INPUT1 : DVI-D
INPUT2 : HD15
Input signal configuration
DVI-D input connector
(digital RGB) for INPUT1
HD15 input connector
(analog RGB) for INPUT2