Install the bin signal.
2.1
6.1
Bin Signal Installation
• Mount the electrical box to the side of the Vision dispenser
Note: If a 4 x 4 box is mounted to a non-grounded surface, connect ground wire at an
appropriate ground.
• Connect the bin signal cord to the plug on the electrical box.
• Insert 16" (61 cm) of the long bin signal cable
docking station
➍
• After sliding the ice machine module into the louvered docking station, disconnect one wire from
shuttle switch and replace with wire from adapter plug.
• Connect wire removed from shuttle switch to male connector on adapter plug wire.
• Complete normal installation procedure for the ice machine using the installation manual that
shipped with the ice machine.
• Connect adapter plug into bin signal plug.
12
➎
➌
24"
(610 mm)
and secure in place with strain relief provided.
remote condensing
➏
➊
to establish a ground connection.
➋
➌
into the hole in the back of the louvered
➎
➐
Cornelius • RIDE Technology
Bin signal
➐
➋
Ground
➊
➌
➏
6