File Image Method Settings; Clone Method Settings - Logicube ZClone Xi User Manual

4.3.5 File Image Method Settings

The File Image Method Settings screen allows the user to select a file image output
mode. The output modes available are:



4.3.6 Clone Method Settings

When Drive to Drive or Drive to Image mode is selected, Clone Method Settings will
appear on the top-right of the Settings screen. Depending on the cloning method
chosen, the Clone Method Settings screen has can have different settings:
Mirror – If mirror is selected or used, the following settings are available:



This screen also displays an option to select whether the Master drive is a part of a RAID
configuration or a NON-RAID configuration.
Clever – If clever is selected or used, the following settings are available:

Logicube ZClone™Xi User's Manual
Mirror – Creates a bit-for-bit image of the Master.
Clever – Copies only sectors containing data and compresses the image file.
Length – Set the percentage or number of blocks to clone. By default, this is set
to 100% of the Master.
Master Start – Set the percentage or number of blocks from the start of the
Master. By default, this is set to 0%, or the beginning of the Master.
Target Start – Set the percentage or number of blocks from the start of the
Target. By default, this is set to 0%, or the beginning of the Target.
The specific number of blocks
can be set for each of the options
by tapping the
When cloning from drives from a RAID configuration,
the Target drives may need to be initialized through
the computer's RAID controller before being cloned to.
Partition Resize – This screen will show the number of partitions found on the
Master drive and for each supported partition, a resize percentage setting will be
shown.
It is recommended that all System Restore, Recovery, and OEM partitions
should not be expanded. Setting the slider/percentage to 0% will instruct
the unit to keep the same partition size. The percentage value, when set
from 1 to 100 will determine what percentage of the Target drive(s) will be
used. For example, setting the percentage value to 100% would instruct
the unit to use the entire remainder of the Target drive for that partition.
(edit) icon.
CLONE
33