Location And Function Of Parts And Controls; Front Panel - Sony LMD-2030W Operating Instructions Manual

Location and Function of Parts and Controls

Front Panel

1
qf
a
Tally lamp
You can check the status of the monitor by the color of the tally
lamp.
The tally lamp lights in red, green or amber depending on the
setting of the REMOTE PARALLEL menu.
b
POWER switch and indicator
Press to turn on the power. The indicator turns on. Press again to
turn off the power.
c
KEY INHIBIT indicator
Lights when the key inhibit function works.
For details on the key inhibit, see "KEY INHIBIT menu" (page 19).
d
VOLUME buttons
Press the + button to increase the volume or the – button to
decrease it.
e
Menu operation buttons
Displays or sets the on-screen menu.
M/m/</, (arrow) buttons
Select the menu or make various adjustments.
MENU button
Press to display the on-screen menu.
Press again to clear the menu.
RESET button
Resets the value of an item back to the previous value.
This button functions when the menu item is adjusted
(displayed) on the screen.
8
Location and Function of Parts and Controls
RGB/ EXT BLUE
LINE A HDMI SDI SCAN ASPECT
COMPONENT SYNC ONLY
qd qs qa 0 9 8 7 6
ENTER button
Press to confirm a selected item on the menu.
f
ASPECT select button
Sets the aspect ratio of the picture, 4:3 or 16:9.
g
SCAN select button
You can change the scan size of the picture.
Press to change the scan size among over (5 % over scan), under
(–3 % under scan) and full screen set on the SCAN menu
(page 18).
h
BLUE ONLY button
Press to eliminate the red and green signals. Only blue signal is
displayed as a monochrome picture on the screen. This mode is
convenient for chroma and phase adjustments and monitoring of
VCR noise.
i
EXT SYNC (external sync) button
Press to operate the unit on an external sync signal through the
EXT SYNC IN connector.
The EXT SYNC button works when the component/RGB signals
are input.
j
SDI button
Press to monitor the signal through the OPTION IN connector.
k
RGB/COMPONENT button
Press to monitor the signal through the RGB/COMPONENT
input connector.
l
HDMI button
Press to monitor the signal through the HDMI IN connector.
MENU
VOLUME
POWER
KEY
INHIBIT
RESET ENTER
5 4 3 2