Printing Signal Array Data - GE DigitalFlow GF868 Programming Manual

4.7 Printing Signal Array Data

SGNLS
Use the submenu to print signal array data, to help diagnose certain problems. To print the signal data, see
Figure 16 on page 92 and complete the following steps:
IMPORTANT:
Make sure that a printer has been properly set up before proceeding with this section.
1. To access the Print Menu, press the
Note: The Print Menu is not protected by the security feature and a password is never required to access this menu.
2. Press the [ or [ key to display the option bar shown, and then press
[F1]-[F3]
3. Press the keys to select the desired Signal Array data to print. To abort the procedure, press the
Note: The
SIGNL
option causes the raw signal array data to print, while the
cross-correlation data to print. The
After the desired print selection has been made, the Model GF868 returns to the standard data display screen and
normal measurement taking. The specified signal array data is printed continuously, until it is manually stopped. To
terminate signal array printing, use the
printout is shown in Figure 8.
DigitalFlow™ GF868 Programming Manual (2-Channel)
[PRNT]
key.
BOTH
option prints both sets of data.
STOP
submenu, as described earlier in this chapter. A portion of a typical
CH1 SKAN
0 2
1 2
2 2
.
.
.
757 40
758 41
759 40
760 34
761 32
762 36
Figure 8: Typical Signal Array Printout
[F2]
to select the
CROSS
option causes the
SIGNAL
0
0
0
44
45
42
34
34
38
Chapter 4. Printing Data
SGNLS
submenu.
[EXIT]
key.
69