Data Pulse Input Event - YSI ProSample Series User Manual

Digital Pulse Input Event
In this program, sampling will occur each time the ProSample receives a pulse from a digital device (e.g. a data logger).
Please refer to the user manual of your device to ensure it is programmed as desired.
All ProSample models can be used for this sampling scenario. A flow signal cable (item # 630147) must be connected
to the digital device and the ProSample. As is shown in the
yellow wires should be used when connecting the flow signal cable to the digital device.
NOTE: The settings modified in the section
and every program, so it is important these settings are carefully set before starting any program.
NOTE: Screenshots demonstrate an example setup. Settings should be adjusted for your specific application.
Programming: Digital Pulse Input Event
Flow Signal Cable Wiring
Configure Key Instrument Settings
1. From the Main Menu, select Programs g Change. Choose the
program you would like to modify by using the left and right
arrow keys. In this example, we will modify Program # 1. Press
the Enter key to begin modifying the program.
2. Highlight Flow Digital and press the Enter key.
3. Enter 0001 for Sample After. The data logger will send a pulse
to the ProSample when a sample needs to be taken.
section on page 24, the grey and
on page 22 will be applied to each
45