Sony GigaJuke NAS-E35HD Operating Instructions Manual page 61

Tracks cannot be played back.
Only tracks in the MP3 (".mp3"), WMA

(".wma") and AAC (".m4a") format can be
played on this unit. Tracks in other formats
cannot be played (page 35).
USB device formatted with file systems other

than FAT16 or FAT32 are unsupported.*
If you use partitioned USB device, only MP3,

WMA and AAC tracks on the first partition
can be played.
Playback is possible up to 8 levels.

The number of folders has exceeded 999.

The number of tracks has exceeded 999.

Files that are encrypted or protected by

passwords, etc. cannot be played back.
* This unit supports FAT16 and FAT32, but some USB
1
device may not support all of these FAT. For details, see
the operation manual of each USB device or contact the
manufacturer.
Timer
The Play Timer or Recording Timer does not
work.
Set the clock correctly (page 21).

A power failure occurred while the timer

setting was in standby mode or the power
cord was disconnected.
The unit is being subjected to shocks or

vibrations. Place the unit at a stable location.
The contents recorded by the Recording
Timer is not complete. Some of the material
at the beginning or in the middle are
missing.
Set the clock correctly (page 21).

A power failure occurred while the timer

setting was in standby mode or the power
cord was disconnected.
The unit was subjected to shocks or vibrations.

Place the unit at a stable location.
Title Update
Title Updater cannot be used on the
computer.
Use a USB storage device supported by the

unit (page 71).
1
An error occurs when you run Title Updater
on the computer.
Close Virtual Expander (MICROVAULT

software) first, and then run "TitleUpdater.
exe" again.
"export.dat" file cannot be exported.
Only album information (audio data)

recorded from audio CDs can be exported.
Album information that has been imported

using the Title Updater cannot be exported.
Make sure that the USB storage device is

connected firmly to the unit.
You have disconnected the USB storage device

before "Device Stop" appears on the unit's
display.
The USB storage device or Title Updater is
not recognized by the computer.
Disconnect the USB storage device, and then

reconnect it correctly.
The "import.dat" file cannot be saved.
The USB storage device is full. Delete

unnecessary data from the USB storage device.
The USB storage device is write-protected.

Undo the write-protection.
1
GB