the logger's operating temperature (i.e. the temperature of the logger itself)
does not exceed 55°C/131°F.
For alkaline batteries, the battery-charge level displayed by Insight (p. 19) will
be valid only if Duracell or other quality batteries are fitted. Using inferior batteries
Life of Alkaline Batteries
The data below can serve as a guide – though the values given are no more than
an indication of the battery life that can be expected. See p. 19 for general
considerations that affect actual battery life.
No. of
Sample
Channels
Interval
(sec.)
10
3
10
3
10
60
10
60
20
3
20
3
20
60
20
60
20
180
20
180
Replacing Alkaline Batteries
Carry out as follows.
1. Ensure the logger is powered off: press green and red buttons together,
and hold for 5 seconds.
2. On the side of the logger, remove the single screw securing the battery-
compartment door. See photo, p. 11.
3. Turn the logger to let the old batteries slide out of the housing, one at a
time, and dispose of them appropriately (see p. 34).
4. Slide new batteries into the housing, one at a time, observing polarity.
Check that you are using the correct battery type for the battery housing
fitted. If in doubt, remove the housing (see p. 23) and check the label on it.
24
Specifications and Operation
may cause misleading percentages to be shown.
Logger
Temperature
25°C/77°F
70°C/158°F
25°C/77°F
70°C/158°F
25°C/77°F
70°C/158°F
25°C/77°F
70°C/158°F
25°C/77°F
70°C/158°F
Battery Life (hrs)
No Radio
Radio
Telemetry
Telemetry Used
–
–
–
150
–
–
450
–
–
–
–
210
–
–
370
–
–
–
–
420
DATAPAQ TP3