Fluke Datapaq TP3 User Manual page 4

SAFETY
WARNINGS
Indicates potential hazard.
On Datapaq equipment this normally warns of high temperature, but,
where you see the symbol, consult the manual for further explanation.
Warns of high temperatures.
Where this symbol appears on Datapaq equipment, its surface may be
excessively hot (or excessively cold) and may thus cause skin burns.
The following product type
Datapaq TP3 Thermocouple Data Logger
manufactured by Fluke Process Instruments,
Lothbury House, Cambridge CB5 8PB, UK
complies with the requirements of regional
directives as follows.
International Electrotechnical Commission
IEC 61010-1:2010 (3rd edition) – Safety requirements
for electrical equipment for measurement, control,
and laboratory use.
European Union
Directive 2014/30/EU – ElectroMagnetic
Compatibility (EMC).
EN 61326-1:2013 – Group 1, Class B equipment
(emissions section only), and Industrial Location
Immunity (immunity section only).
Directive 2014/53/EU – Radio Equipment Directive (RED).
EN 300 220-2 V2.4.1 – Electromagnetic
compatibility and Radio spectrum Matters (ERM);
Short Range Devices (SRD); Radio equipment to
be used in the 25 MHz to 1000 MHz frequency
range with power levels ranging up to 500 mW;
Part 2: Harmonized EN covering essential require-
ments under article 3.2 of the R&TTE directive.
EN 300 328 V1.8.1 – Electromagnetic compatibility
and Radio spectrum Matters (ERM); Wideband
Fluke Process Instruments makes no representations or warranties of any kind whatsoever with
respect to the contents hereof and specifically disclaims any implied warranties of merchantability or
fitness for any particular purpose. Fluke Process Instruments shall not be liable for errors contained
herein or for incidental or consequential damages in connection with the furnishing, performance or
Fluke Process Instruments reserves the right to revise this publication from time to time and to make
changes to the content hereof without obligation to notify any person of such revisions or changes.
Datapaq and the Fluke Process Instruments logo are registered trademarks of Fluke Process
Instruments. Microsoft and Windows are registered trademarks of Microsoft Corporation.
User manuals are available in other languages; contact Fluke Process Instruments for details.
For safe use of Datapaq equipment, always:
• Take care to follow its supplied instructions.
• Observe any warning signs shown on the equipment.
Directive 2011/65/EU – Restriction of the use of
certain hazardous substances in electrical and
electronic equipment (RoHS).
Federal Communications Commission, USA
Electromagnetic Compatibility Directive for digital
devices.
use of the Datapaq software, associated hardware or this material.
transmission systems; Data trans mission equip-
ment operating in the 2.4 GHz ISM band and using
wide band modulation techniques; Harmonized EN
covering the essential require ments of article 3.2
of the R&TTE directive.
EN 301 489-1 V1.9.2 – Electromagnetic compatibility
and Radio spectrum Matters (ERM); ElectroMagnetic
Compatibility (EMC) standard for radio equipment
and services; Part 1: Common technical requirements.
EN 301 489-3 V1.4.1 – Electromagnetic compatibility
and Radio spectrum Matters (ERM); ElectroMagnetic
Compatibility (EMC) standard for radio equipment
and services; Part 3: Specific conditions for Short
Range Devices (SRD) operating on frequencies
between 9 kHz and 40 GHz.
EN 301 489-17 V2.2.1 – Electromagnetic
compatibility and Radio spectrum Matters (ERM);
ElectroMagnetic Compatibility (EMC) standard for
radio equipment; Part 17: Specific conditions for
Broadband Data Transmission Systems.
CFR47 Class A – Code of Federal Regulations:
Part 15 Subpart B, Radio Frequency Devices,
Unintentional radiators.
© Fluke Process Instruments, Cambridge, UK 2018
All rights reserved
Manual set in 10 pt Gill Sans.