Trouble Shooting - Titan TT-CBC1580SZ Owner's Manual

Trouble Shooting
PROBLEM
The appliance does not
turn on.
The appliance turns on
and off frequently.
The appliance does not
reach the desired
temperature/The
appliance is not cold
enough.
The appliance is making
strange sounds.
The body of the
appliance is electrified.
Frost is forming in the
appliance.
The door does not shut
properly.
POSSIBLE CAUSE
There is a power failure.
•
The unit is not plugged in.
•
A house fuse has blown or
•
the circuit breaker is
tripped.
The ambient temperature is
•
too high.
The door is being opened
•
too often.
The door is not closed
•
properly.
The door gasket is not
•
sealing properly.
Inadequate ventilation
•
around the unit.
The unit is installed too
•
close to heat source(s).
Inadequate ventilation
•
around and behind the unit.
The door is opened too
•
frequently or for long
periods of time.
Some sounds are normal.
•
The unit is not properly
•
leveled.
The unit is touching another
•
appliance.
The unit is not properly
•
grounded.
The environment is too
•
humid.
The ambient temperature is
•
too low.
The door is opened too
•
frequently.
The unit is not leveled
•
properly.
The door gasket is dirty.
•
The door gasket is not
•
installed incorrectly.
The shelves are incorrectly
•
installed.
www.titan-appliances.com
SOLUTION
Ensure the power outlet has power.
•
Check and plug the unit in to a power
•
outlet that has sufficient amperage.
Replace the blown fuse or reset the
•
breaker.
Run the appliance at the appropriate
•
recommended ambient temperature.
Avoid opening the door too frequently.
•
Make sure the door is closed properly.
•
Make sure the door gasket is properly
•
sealed.
Read and observe the 'Clearance
•
Requirements' section of this owner's
manual
Keep the unit away from heat sources, e.g.
•
direct sunlight.
Read and follow the 'Installation Clearance
•
Requirements' section of this manual.
Close the door tightly and do not open the
•
door too frequently or for long periods of
time.
Read the 'Sounds' section.
•
Check to make sure that the unit is leveled.
•
Ensure the unit is not touching another
•
appliance or furniture.
Contact your local electrician to test your
•
electrical grounding system.
This unit has an 'auto-defrost' system,
•
however, manual defrosting may still be
required under some conditions. If frost
builds up, try running the cooler at a
warmer temperature setting, minimizing
the number of door openings, or unplug
the unit to defrost.
Make sure the cooler is properly leveled
•
before operating.
Clean the door gasket.
•
Make sure the door gasket is properly
•
installed.
Make sure the shelves are installed
•
correctly – refer to 'Installing the Door
Handle and Shelve' Section of this manual.
15