Installing The Door Handle And Shelves - Titan TT-CBC1580SZ Owner's Manual

Installing the Door Handle and Shelves
THE DOOR HANDLE:
1. Open the door, carefully pull the door gasket around the area where the handle is to be installed,
and remove the two pre-installed decorative plugs from the front of the door. (Note: some models
do not have decorative plugs installed.)
2. Insert the Phillips head screws through the gasket side of the door and pass through the door.
3. Align the handle with the screws and hand-tighten using a Phillips head screwdriver until the handle
is flush against the door frame. (CAUTION: Do not over-tighten the screws as this may cause
damage to the handle or to the stainless steel door.)
4. Carefully press the door gasket back into its original position.
THE SHELVES:
This appliance is equipped with glass shelves.
To install:
Open the door completely - make sure to open the door all the way before pulling the shelves
•
out of their track to prevent damaging the door gasket.
Slide the shelf on the shelf track and gently push back until it stops.
•
Install the plastic notches.
•
To remove:
Open the door completely- make sure to open the door all the way before pulling the shelves
•
out of their track to prevent damaging the door gasket.
Remove all the contents sitting on the shelf, if any.
•
Remove both plastic notches with a screwdriver
•
Then proceed to pull out the shelf slowly.
•
www.titan-appliances.com
9