Disassembly Procedure - Yamaha Clavinova CVP-205 Service Manual

DISASSEMBLY PROCEDURE

1. Floppy Disk Drive
(Time required: About 10 minutes)
1-1 Remove the four (4) screws marked [50A]. The FDD unit
can then be removed. (Fig. 1)
1-2 Remove the four (4) screws marked [8A]. The FDD cover
can then be removed. (Fig. 2)
1-3 Remove the screw marked [3A]. The earth wire can then
be removed. (Fig. 3)
1-4 Remove the three (3) screws marked [3B]. The floppy disk
drive can then be removed from the FDD holder. (Fig. 3)
• Bottom view
Mic. & phones unit
[15A]
[35c]
Arm assembly L PK connector assembly
[15]: Truss Head Tapping Screw-1 3.5x25 MFZN2BL (EN630190)
[35c]: Bind Head Tapping Screw-B 3.0x8 MFZN2BL (EP600190)
[8A]
[8A]: PW Head Tapping Screw-B 3.0x8-8 MFZN2BL (V2276900)
2. Mic. & Phones Unit, MIC Circuit Board,
HP Circuit Board
(Time required: About 10 minutes)
2-1 Remove the four (4) screws marked [50B]. The mic. &
phones unit can then be removed. (Fig. 1)
2-2 Remove the input volume knob and the hexagonal nut marked
[40A]. The MIC circuit board can then be removed. (Fig. 4)
2-3 Remove the two (2) hexagonal nuts marked [40B]. The
HP circuit board can then be removed. (Fig. 4)
Jack unit
[50B] x 4
[71] x 7
Back top board assembly
FDD cover
Fig. 2
[112] x 4
[15B] x 6
FU assembly
[50]: Bind Head Tapping Screw-1 3.5x14 MFZN2BL (EP030250)
Fig. 1
GND Wire GND Wire
[3B]
FDD holder
[3]: Bind Head Screw 3.0x5 MFZN2Y (EG330150)
CVP-205/CVP-205M
[50A] x 4 FDD unit
Arm assembly R
[3A]
FDD
Fig. 3
[15A]
10