Yamaha Clavinova CVP-205 Service Manual page 11

CVP-205/CVP-205M
• Bottom view
Knob
3. Music Rest Assembly
(Time required: About 5 minutes)
3-1 Remove the four (4) screws marked [7A]. The music rest
assembly can then be removed. (Fig. 5)
4. Back Board Assembly
(Time required: About 5 minutes)
4-1 Remove the two (2) screws marked [BA] and the five (5)
screws marked [D]. The back board assembly can then be
removed. (Fig. 6)
Music rest assembly
[7A]: Bind Head Tapping Screw-1 3.0x16 MFZN2BL (EP030310)
5. Units and Assemblies (Back Board Assembly)
(Time required: About 10 minutes each)
Remove the following screws after removing the back
board assembly. Each unit and assembly can then be
removed. (Table-1)
Circuit Board and Unit
Speaker Box Assembly (L, R)
Jack Unit
FU Assembly
11
[40A] [40B]
[40]: Hexagonal Nut 12.0 14x2 MFZN2BL (VB508600)
[7A]
(Two each of the right and left)
Fig. 5
Ref. No.
[6A] Truss Head Screw 4.0x30 MFZN2Y (V5877100)
[71] Bind Head Tapping Screw-1 3.5x12 MFZN2BL (EP030340)
[112] Truss Head Tapping Screw-1 3.5x30 MFZN2Y (VA076400)
• Side view
Mic. & phones unit
Knob
Fig. 4
• Rear view
Back board assembly
[BA]: Truss Head Screw 4.0x14 MFZN2BL (VB931700)
[D]: Truss Head Tapping Screw-1 4.0x20 MFZN2BL (03747290)
[5]: Truss Head Screw 4.0x16 MFZN2BL (V6207400)
Screw
Table-1
HP
MIC
[5]
[BA]
[D]
[D]
Fig. 6
QTY
16
7
4
[BA]
[D]
Fig.
7
1
1