Table of Contents
Advertisement
11.2
Door Settings
Relay Output Delay Time
To set door relay strike time
Door Open Detection
Door Open Too Long (DOTL) warning. When used with an optional magnetic contact or built-in
magnetic contact of the lock, if the door is opened normally, but not closed after 1 minute, the inside
buzzer will beep automatically to remind people to close the door and continue for 1 minute before
switching off automatically.
Door Forced Open warning. When used with an optional magnetic contact or built-in magnetic contact
of the lock, if the door is forced open, or if the door is opened after 20 seconds of the
electro-mechanical lock not closed properly, the inside buzzer and alarm output will both operate. The
Alarm Output time is adjustable between 0-3 minutes with the default being 1 minute.
To disable door open detection. (Factory
default)
To enable door open detection
Alarm output time
To set the alarm output time (0-3 minutes)
Factory default is 1 minute
Keypad Lockout & Alarm Output options. If there are 10 invalid cards or 10 incorrect PIN numbers
in a 10 minute period either the keypad will lockout for 10 minutes or the alarm will operate for 10
minutes, depending on the option selected below.
Normal status: No keypad lockout or
alarm (factory default)
Keypad Lockout
Alarm Output
To remove the alarm
To reset the Door Forced Open warning
To reset the Door Open Too Long warning
4
0～99
# *
0-99 is to set the door relay time 0-99 seconds
6
0
#
6
1
#
9
0～3
#
7
0
# (Factory default setting)
7
1
#
7
2
#
Read valid card or Master Code #
Close the door or Read valid card or Master Code #
9
Advertisement
Table of Contents
