Lan Remote Control - Acer DV555K User Manual

LAN Remote Control

When you connect the display and the computer using a LAN hub and a LAN cable (See "LAN
Connection:" on page 27), and then configure the network settings using Ethernet Setting in the
Setup menu of the OSD, you can control the display remotely using the same commands as for
RS-232C.
Setting procedure:
1. Select LAN as the communication interface used for the serial communication function. (See
"Controlling the Display Remotely" on page 52, and also "SETUP" on page 38 to adjust the
Control Setting function in the Setup menu.)
2. Set the following network parameters using the OSD menu.
• DHCP client ON/OFF, IP address, subnet mask and default gateway.
3. Set the IP address described above and the port number (4660) using the application program
of your computer to perform the socket communication.
4. Send the same control command as for RS-232C via TCP/IP socket communication.
5. Check the return command sent from the display. When it is received successfully, the setting
is complete.
• Broadcast mode: Set command with ID="0" (0x00) will set all monitors in the same time, and
they will not reply command.
• If LAN mode is used, ID is not the identification for each of the monitor but IP, and the
monitor will reply the same ID as received from the controller except "0".
NOTE
OSD (On-Screen-Display) Controls | 57