SETUP
Power Save
EDID Switch
Detect Signal in Standby
HDMI CEC
Software Update (USB)
Restore Default
Change the Power Save setting or set Power Save Mode to OFF.
Change the EDID Switch setting. If the signal source does not
support YCbCr: 4:4:4, then the following settings are available:
• EDID 1.4: supports up to 3840x2160@60Hz YCbCr 4:2:0
• EDID 2.0: supports up to 3840x2160@60Hz YCbCr 4:4:4
Change the Detect Signal in Standby setting to ON or OFF.
When the Detect Signal in Standby is ON, the display will wake up
when a signal input is detected from HDMI1, HDMI2, DVI-D, DP or
VGA.
Select the HDMI CEC settings to ON or OFF.
Updates software via the USB port.
Resets the settings in the Setup menu back to their factory settings.
FUNCTION
OSD (On-Screen-Display) Controls | 39