Ricoh DD 4450 Service Manual page 230

Idling after how many prints
If SP 2-28 is set to 'YES', the idling motor turns if 3 or more prints were
2-29
made.
If SP 2-28 is set to 'NO', the idling motor turns if the number of prints made
is the same as or more than the setting of SP 2-29.
2-31 Ink Auxiliary Supply
Ink supply after trial
2-32
Ink is detected and supplied after the trial print when this SP is on.
Re-Feeding setting
When the machine performs re-feeding, the paper registration position can be
up to 5mm out of range. If this position is not acceptable to the customer,
2-33
change this SP mode to "OFF".
ON: Re-feeding is on (factory setting).
OFF: Re-feeding is off.
Slow starting mode
Increase the image density of trial prints.
The figures below are drum-rotating speeds. A setting of "30rpm" will increase
the image density of trial prints.
This mode was added because trial print images are lighter than with other
models.
2-34
<30rpm>
Trial Print: 30rpm
1st Print: 45rpm
2nd Print: 60rpm
3rd Print: 75rpm
4th Print: 90rpm
5th Print: 105rpm
6th Print: 130rpm
SM Appendix
[1 to 5 / 3 / 1 Print]
[0:After 1:Before 2:No / 0:After / - ]
[ ON-OFF / OFF / -]
[ ON-OFF / ON / -]
[30rpm / 45rpm / 45rpm /-]
<45rpm>
Trial Print: 45rpm
1st Print: 60rpm
2nd Print: 75rpm
3rd Print: 90rpm
4th Print: 105rpm
5th Print: 130rpm
6th Print: 130rpm
11
SP Table
C279