Ricoh DD 4450 Service Manual page 229

SP Table
Ink setting
2-21
Double count-up (A3)
When using A3 Drum, electromagnetic counter (master, paper) count up every 2
/ print.
2-22
0: As usual, one count increase.
1: Two counts increase only master. Paper increase one count.
2: Two counts increase both master and the paper.
Key card count setting
This function is used to specify the number of sheets to be printed per Key Card
counter count.
2-23
0:Master
1:Only Print number(Master revision)
2: Only Print number(Number conversion)
Key card master count conv.
This function is valid only if the key card count setting is 1.
2-24
Example: If this SP is set to 20 (in other words, if you decide that the cost of one
master is 20 times the cost of one print), every time one master is made, the
print count increases by 20.
Key card print count setting
2-25
This function is valid only if the key card count setting is 2.
The number of sheets to be printed per print counter count.
Idling after less than 3 prints
Ensures that the first print has sufficient ink density if the machine was not used
for a long time. Also, when the customer continuously prints small numbers (1 to
3 prints), ink leaks occur from the trailing edge of the drum.
2-28
When SP 2-38 is on, the idling roller motor turns to press the drum idling roller
against the inner surface of the drum screen after printing. Then, the idling motor
turns to remove the ink leaks. The idling motor action depends on the settings of
SP 2-28 and 2-29.
C279
[0 to 1 / 0 / 1]
[0 to 2 / 0 / 1]
[0 to 2 / 0 / 1]
[0 to 20 / 1 / 1Print]
[0 to 3 / 1 / 1Print]
[YES - NO / NO / -]
10 SM Appendix