Table of Contents
Advertisement
Scanner Unit
5.
Insert the left end into the slit [B]. The end should go via the rear track of the left pulley [C] and
the rear track of the movable pulley [D].
6.
Hook the right end onto the front scanner wire bracket [A]. The end should go via the rear
track of the right pulley [B] and the rear track of the movable pulley [C].
Do not attach the scanner wire bracket with the screw at this time.
7.
Remove the tape from the drive pulley.
8.
Insert a scanner positioning pin [A] through the 2nd carriage hole [B] and the left holes [C] in
the front rail. Insert another scanner positioning pin [D] through the 1st carriage hole [E] and
the right holes in the front rail [F].
9.
Insert two more scanner positioning pins through the holes in the rear rail.
C279
4-28
SM
Advertisement
Chapters
Table of Contents
