1.
In the screen shown above, enter your admin password in the New Admin Password and Confirm Password fields (see below).
Ensure that the Password Strength of your password is at least Medium (preferably Strong).
NOTE
If you forget your password, you will be unable to login the system, please contact your vendor to reset the password.
2.
If you want to use an Unlock Pattern to access the configuration menus, open the Unlock Enable drop down list, and then click
Enable. Click Apply to continue.
3.
Click the Draw button to open the Set Unlock Pattern window.
4.
In the Set Unlock Pattern window, drag the mouse cursor across a pattern of circles, then release the mouse.
6
www.Observint.com
Repeat the pattern you entered, and then click Apply to save the configuration. The configuration Wizard initial screen will open.
5.
Using the Wizard for initial configuration
Use the Wizard to setup the basic configuration of your system. Advanced configuration options are available in the Setup menus. Refer to the
firmware user manual (to be provided) for your recorder for more information.
1.
When the initial Wizard window appears, click Start Wizard to continue.
2.
The next Wizard screen is used to configure the network settings of the recorder. Initially, the recorder acquires network using DHCP
(Dynamic Host Configuration Processor) which usually exists somewhere on your LAN. DHCP provides network settings that are
compatible with other devices on your LAN.
© 2019 Observint Technologies. All rights reserved.