Table of Contents
Advertisement
e.
Connect the SATA data and power cables to each HDD. See above.
5.
Use the method described above to install additional HDDs if needed.
6.
Reinstall the NVR cover.
Step 3. Install the NVR
1.
Place the NVR in a location that is secure, well ventilated and clean. The NVR should be positioned such that the back panel connectors
are accessible and the ventilation holes on the top and sides are not blocked.
2.
Connect the ground terminal on the back of the NVR (if available) to an earth ground. Refer to local electrical codes for grounding
requirements.
Do not apply power to the NVR at this time.
CAUTION
Step 4. Connect devices to the NVR
Your NVR security system is highly configurable and is designed meet most application requirements. Refer to the Specifications section
for more information about the capacities of your NVR.
Cameras
Install your security cameras. Always follow the installation instructions provided with the camera.
1.
Install the analog cameras that will connect to the LAN1 .. LAN8 connectors on the back of the NVR.
2.
Route Ethernet extension cable(s) between the cameras and the NVR.
3.
Connect the extension cable(s) to the camera(s) and the NVR.
5
www.Observint.com
Install a monitor, mouse, microphones, network, power etc
For the following steps, refer to the back panel photo above for the location of connectors.
1.
Install and setup your monitor in accordance with the instructions provided with the monitor. Do not power it on at this time.
Some monitors have multiple inputs such including VGA ,HDMI, etc. If you are using this kind of monitor, configure your monitor to display
NOTE
the input connected to your NVR (HDMI or VGA).
2.
Cable the HDMI or VGA connector to your monitor's HDMI or VGA input. The HDMI interface provides the best performance.
3.
Plug the mouse provided into the USB 2.0 connector on the front or back of the NVR.
4.
Plug a drop cable from your local area network (LAN) router into the RJ45 WAN connector on the back of the NVR.
5.
If using speakers, plug your speaker set into the AUDIO OUT RCA female connector on the back of the NVR. The AUDIO OUT connector
provides a line level signal output. An audio adapter may be needed to connect your speaker set to the NVR RCA connector.
6.
Connect the power cord with the 48 Vdc power adapter, and then connect the power adapter to the 48 V(DC) power connector on the
back panel of the NVR, and then into a UPS (recommended) or surge protector.
Power on the system
1.
Apply power to your power adapter. Because the NVR does not have a power switch, applying power to the adapter will power on the
NVR.
2.
Apply power to the monitor.
3.
If using a speaker set, apply power to your speakers.
Step 5. Using the Wizard for basic configuration setup
When the NVR powers on, a "SYSTEM INITIALIZING" splash screen normally appears within 3 minutes. An a system activation screen will
appear.
Activation
If it is the first time powering on the recorder, an activation screen will appear. You must use this menu to setup an admin password for the
system, and an Unlock Pattern, if preferred, for quickly accessing the configuration menus if the recorder.
© 2019 Observint Technologies. All rights reserved.
Advertisement
Table of Contents
