Controlling Your Tv Or Av Amplifier (Receiver) With The Supplied Remote - Sony DVP-NS915V Operating Instructions Manual

Controlling Your TV or AV
Amplifier (Receiver) With
the Supplied Remote
By adjusting the remote signal, you can
control your TV with the supplied remote.
If you connect the player to an AV amplifier
(receiver), you can control the volume with
the supplied remote.
Notes
• Depending on the connected unit, you may not be
able to correctly control your TV or AV amplifier
(receiver) using some of the buttons below.
• If you enter a new code number, the code number
previously entered will be erased.
• When you replace the batteries of the remote, the
code number you have set may be reset to the
default setting. Set the appropriate code number
again.
Controlling TVs with the remote
TV/DVD
switch
Number
buttons
-/--*
* DVP-NS915V only
1
Slide the TV/DVD switch to TV.
2
Hold down [/1, and enter your TV's
manufacturer code (see "Code
numbers of controllable TV's" below)
using the number buttons.
70
3
When the TV/DVD switch is set to TV, the
remote performs the following:
[/1
VOL +/–
For DVP-
NS755V:
WIDE MODE
For DVP-
NS915V:
WIDE MODE
TV/VIDEO
For DVP-
NS755V:
Number buttons
and ENTER
For DVP-
NS915V:
[/1
Number buttons
VOL +/– and -/--*
TV/VIDEO
* When you use the number buttons to select the
WIDE
TV's channel, press -/-- followed by the number
MODE
buttons for two-digit numbers.
Release [/1.
Turns the TV on or off
Adjusts the volume of the TV
Switches to or from the wide
mode of a Sony wide TV
Switches to or from the wide
mode of a wide TV
Switches the TV's input
source between the TV and
other input sources
The button works even if the
TV/DVD switch is set to
DVD
Selects the channel of the TV
Selects the channel of a Sony
TV