Sony DVP-K56P Operating Instructions Manual page 21

SCREEN SETUP
TV TYPE:
SCREEN SAVER:
BACKGROUND:
4:3 OUTPUT:
7
Press X/x to select the setting that
matches your TV type.
◆ If you have a wide-screen TV or a 4:3
standard TV with a wide-screen mode
• 16:9 (page 61)
◆ If you have a 4:3 standard TV
• 4:3 LETTER BOX or 4:3 PAN SCAN
(page 61)
8
Press ENTER.
The Setup Display for selecting the type
of jack used to connect your amplifier
(receiver) appears.
Is this player connected to an amplifier
(receiver) ? Select the type of jack you
are using.
YES
LINE OUTPUT L/R (AUDIO)
DIGITAL OUTPUT
NO
9
Press X/x to select the type of jack
(if any) you are using to connect to
an amplifier (receiver), then press
ENTER.
If you did not connect an AV amplifier
(receiver), select "NO," then go to step
13.
If you connected an AV amplifier
(receiver) using just an audio cord, select
"YES: LINE OUTPUT L/R (AUDIO),"
then go to step 13.
If you connected an AV amplifier
(receiver) using either a optical or coaxial
digital cord, select "YES: DIGITAL
OUTPUT."
10
Press X/x to select the type of
Dolby Digital signal you wish to
send to your amplifier (receiver).
16:9
16:9
4:3 LETTER BOX
4:3 PAN SCAN
If your AV amplifier (receiver) has a
Dolby Digital decoder, select "DOLBY
DIGITAL." Otherwise, select "D-PCM."
AUDIO SETUP
AUDIO DRC:
DOWNMIX:
DIGITAL OUT:
DOLBY DIGITAL:
MPEG:
DTS:
48kHz/96kHz PCM:
11
Press ENTER.
"DTS" is selected.
AUDIO SETUP
AUDIO DRC:
DOWNMIX:
DIGITAL OUT:
DOLBY DIGITAL:
MPEG:
DTS:
48kHz/96kHz PCM:
12
Press X/x to select whether or
not you wish to send a DTS signal
to your amplifier (receiver).
If your AV amplifier (receiver) has a
DTS decoder, select "ON." Otherwise,
select "OFF."
13
Press ENTER.
Quick Setup is finished and connections
are complete.
If your AV amplifier (receiver) has an
MPEG audio decoder, set "MPEG" to
"MPEG" (page 64).
STANDARD
DOLBY SURROUND
ON
D-PCM
D-PCM
DOLBY DIGITAL
48kHz/16bit
STANDARD
DOLBY SURROUND
ON
D-PCM
PCM
OFF
OFF
ON
21